Important things to note before you get started:

Place your BPC157 & TB500 32 pen in the fridge (2-8°C) from the day you receive it.

This pen contains 16 mg BPC-157 and 16 mg TB-500—per pen. This pen is capable of dispensing precise doses of 0.25 mg, 0.5 mg, 0.75 mg, or 1 mg (delivering equal parts of each peptide per dose)

In the box you will receive one 0.5 mg, 0.75 mg and 1 mg 32 pen and 8 single use needles.

Refer to the package insert for detailed on hand information.

The BPC157 & TB500 32 pen can be selected in 0.25 mg, 0.5 mg, 0.75 mg and 1 mg.

You should take one or two doses per day, depending on your injury or recovery plan. This can be marked on the box to keep track.

Your practitioner will advise the dosage, but you typically start with 0.25 mg per day and increase accordingly. The BPC157 & TB500 32 pen is used for ongoing treatment at 0.5 mg, 0.75 mg and 1 mg and up to two times per day.

 

Getting started:

Wash your hands

Check the expiry date of your medication and check that you have the correct medication with the correct dose.

Remove the pen cap.

Place a pen needle on its own by first removing the paper flap. Pull the needle cover off, while holding the pen upright place the pen needle on the top end of the pen and screw it on.

Remove the outer needle cap and then the smaller needle cover. The needle is now exposed.

When you open your pen for the first time you need to prime the pen.

By holding the pen upright, tap the pen lightly for any air bubbles to raise to the top.

Turn the dial to the dash with two dots and push the plunger in.

You can repeat this process until you see a tiny drop of BPC157 & TB500 liquid come out of the needle.

Next, you need to turn the dial to your selected dose.

In this case 0.25 mg is selected and is the predetermined amount that you will inject. This will be 0.25mg of each, BPC157 and TB500.

Using your Pen

There are several areas on the body where you can inject your BPC157 & TB500 into.

The best places on your body to inject BPC157 & TB500 are the front of your thighs, the front of your waist (abdomen) or your upper arms. BPC157 & TB500 should be injected into the subcutaneous tissue. Please refer to the details packaging insert with image showing the different areas.

It is also important to rotate the injection site every time in order to prevent over use of one particular site.

Once you have selected your injection site, clean the area with an alcohol swab.

When you are ready for the injection make sure the selected dose is correct and the dosage selector on the pen shows your desired dosage ie. 0.5 mg.

Place the pen in your hand with a fist-like grip, with your thumb ready to push the plunger in.

Inject the needle at a 90 degree angle to your skin. Use your thumb to push the plunger all the way down. Leave the needle in your skin for a steady count of 6 seconds, then remove the needle at a 90 degree angle.

Once you are done, check that you have delivered the full dose in the dosage window. Your pen plunger should be all the way in. Your dosage selector will now show a white line, as it was before you selected any dosage.

To remove the needle, place the large needle cap over the needle, screw it off and replace the pen cap.

Please dispose of your used needle safely in a “sharps box”.

Remember to store your BPC157 & TB500 pen back in the fridge after use.

It is convenient to fill in the amount of mg (divided into 0.25 mg segments) on the schedule on your box and mark how many you took in your dosage. This can assist in making sure you keep track of how many mg is left.